Windshield wiper and washer switch
WARNING
In freezing temperatures the washer solution may freeze on the windshield and obscure your vision which may lead to an accident. Warm windshield with the defroster before you wash the windshield.
CAUTION
• Do not operate the washer continuously for more than 30 seconds.
• Do not operate the washer if the reservoir tank is empty.
• Do not fill the window washer reservoir tank with washer fluid concentrates at full strength. Some methyl alcohol based washer fluid concentrates may permanently stain the grille if spilled while filling the window washer reservoir tank.
• Pre-mix washer fluid concentrates with water to the manufacturer’s recommended levels before pouring the fluid into the window washer reservoir tank.
Do not use the window washer reservoir tank to mix the washer fluid concentrate and water.
Windshield wiper and washer switch
The windshield wiper and washer operates when the ignition switch is in the ON position.
Push the lever down to operate the wiper at the following speed: 1 Intermittent — intermittent operation can be adjusted by turning the knob toward A (Slower) or B (Faster).
When the speed sensing wiper interval function is turned on, the intermittent operation speed varies in accordance with the vehicle speed.
(For example, when the vehicle speed is high, the intermittent operation speed will be faster.) To turn this function on and off, see “How to use SETTING button”.
For models with the rain-sensing auto wiper system, see “Rain-sensing auto wiper system”.
2 Low — continuous low speed operation
3 High — continuous high speed operation
Push the lever up 4 to have one sweep operation of the wiper.
Pull the lever toward you 5 to operate the washer. Then the wiper will also operate several times.
See also:
INFINITI Advanced Air Bag System (front seats)
WARNING
To ensure proper operation of the passenger’s advanced air bag system, please observe the following items.
● Do not allow a passenger in the rear seat to push or pull on the seatba ...
Initialize entry/exit function
If the battery cable is disconnected, or if the fuse opens, the entry/exit function will not work though this function was set on before. In such a case, after connecting the battery or replacing with ...
Selecting the memorized position
1. Automatic transmission models: Move the selector lever to the P (Park) position.
Manual transmission models: Apply the parking brake.
2. Raise the seatback (Coupe).
3. Use one of the following m ...