4WD shift indicator
The 4WD shift indicator is displayed in the
vehicle information display.
The indicator should turn off within 1
second after placing the ignition switch in
the ON position.
While the engine is running, the 4WD shift
indicator will illuminate the position selected
by the 4WD shift switch. (See the
4WD shift procedure list shown in the
“INFINITI all-mode 4WD® system” earlier in
this section.).
► The 4WD shift indicator may blink while
shifting from one drive mode to the
other. When the shifting is completed,
the 4WD shift indicator will come on. If
the indicator does not come on immediately,
make sure the area around
the vehicle is safe, and drive the
vehicle straight, accelerate or decelerate
or move the vehicle in reverse,
then shift the 4WD shift switch.
► If the 4WD warning light comes on, the
4WD shift indicator turns off.
See also:
Seat synchronization function
The seat synchronization function automatically adjusts the positions of the steering wheel and outside mirrors when the seat is adjusted using the power seat switches.
However, the steering wheel ...
Vehicle-to-vehicle distance control mode operation
Always pay attention to the operation of the vehicle and be ready to manually control the proper following distance. The vehicle-to-vehicle distance control mode of the Intelligent Cruise Control (I ...
Programming HomeLink for Canadian customers
Prior to 1992, D.O.C. regulations required handheld transmitters to stop transmitting after 2 seconds.
To program your hand-held transmitter to HomeLink , continue to press and hold the HomeLink bu ...