Front
The front seats can be warmed by built-in
heaters. The switches located on the
instrument panel can be operated independently
of each other.
1. Start the engine.
2. Select heat range.
► For high heat, push the HI (High)
side of the switch 1 .
► For low heat, push the LO (Low) side
of the switch 2 .
► The indicator light3 will illuminate
when the heater is on.
3. To turn off the heater, push the “HI” or
“LO” side (whichever is selected) of the
switch. Make sure the indicator light
turns off.
See also:
Jump starting
If jump starting is necessary, see “Jump starting” in the “In case of emergency” section of this manual. If the engine does not start by jump starting, the battery may have to be replaced.
Contact ...
Seat belt maintenance
● To clean the seat belt webbing, apply a mild soap solution or any solution recommended for cleaning upholstery or carpet.
Then wipe with a cloth and allow the seat belts to dry in the shade ...
Tire labeling
Federal law requires tire manufacturers to place standardized information on the sidewall of all tires. This information identifies and describes the fundamental characteristics of the tire and also ...