Hood

Hood  - Pre-driving checks and adjustments - Infiniti JX Owners Manual - Infiniti JX

1 Pull the hood lock release handle located below the driver side instrument panel. The hood will spring up slightly.

1 Pull the hood lock release handle located below the driver side instrument panel. The hood will spring up slightly.
2 Push the lever at the front of the hood to the side as illustrated with your fingertips and raise the hood.

When closing the hood, lower it slowly and make sure it locks into place.

WARNING
● Make sure the hood is completely closed and latched before driving. Failure to do so could cause the hood to fly open and result in an accident.
● If you see steam or smoke coming from the engine compartment, to avoid injury do not open the hood.

    See also:

    If your vehicle is stolen
    If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink®. Consult the Owner’s Manual of each device or call the manufacture ...

    Programming HomeLink
    If you have any questions or are having difficulty programming your HomeLink buttons, refer to the HomeLink web site at: www.homelink.com or call 1-800-355-3515. NOTE: Place the ignition switch in ...

    Loading tips
    ► The GVW must not exceed GVWR or GAWR as specified on the F.M.V. S.S./C.M.V.S.S. certification label. ► Do not load the front and rear axle to the GAWR. Doing so will exceed the ...