Seat belts
The seat belts can be cleaned by wiping them with a sponge dampened in a mild soap solution. Allow the belts to dry completely before using them.
See “Seat belts”.
WARNING
Do not allow wet seat belts to roll up in the retractor. NEVER use bleach, dye, or chemical solvents to clean the seat belts, since these materials may severely weaken the seat belt webbing.
See also:
Switch operation
The windshield wiper and washer operates when the ignition switch is in the ON position.
Push the lever down to operate the wiper at the following speed:
1 Intermittent (INT) — intermittent op ...
Good Ride, Better Handling
Though firmer than some in this class — the Mercedes C-Class, for one — the
G37 rides comfortably, especially given our test car's stiffer rear-shock
tuning, 18-inch wheels and lower-profile tires ...
Readiness for Inspection/Maintenance (I/M) test
A vehicle equipped with Four-Wheel Drive
(4WD) should never be tested using a two
wheel dynamometer (such as the dynamometers
used by some states for emissions
testing), or similar equipment. ...