Operating the HomeLink® Universal Transceiver
HomeLink® Universal Transceiver (once programmed) may now be used to activate the garage door, etc. To operate, simply push the appropriate programmed HomeLink® Universal Transceiver button. The red indicator light will illuminate while the signal is being transmitted.
See also:
Reprogramming a single HomeLink® button
To reprogram a HomeLink® Universal
Transceiver button, complete the following.
1. Push and hold the desired HomeLink®
button. Do not release the button until
step 4 has been completed.
2. Wh ...
Clearing the programmed information
Individual buttons cannot be cleared,
however to clear all programming, push
and hold the two outside buttons and
release when the indicator light begins to
flash (in approximately 20 seconds) ...
If your vehicle is stolen
If your vehicle is stolen, you should change
the codes of any non-rolling code device
that has been programmed into
HomeLink®. Consult the Owner’s Manual
of each device or call the manufacture ...